The shell structure form can be divided into plate structure, skeleton structure, and cylinder structure, and the light steel structure shell on the basis of the plate and skeleton shell structure has also been applied in the project. vacuum cleaner constructor adopts the upper bag pumping method. After the skeleton is extracted during bag changing, the dirty bag is put into the ash hopper at the lower part of the box and taken out from the manhole to improve the operating conditions of bag changing. vacuum cleaner constructor box adopts airtight design, good sealing, inspection door with excellent sealing materials, the production process with kerosene leak detection, air leakage rate is very low. The inlet and outlet air passages of vacuum cleaner constructor are compact and the airflow resistance is small.
Next, talk about the box design knowledge of vacuum cleaner constructor:
First, the box adopts air tightness design, good sealing, excellent sealing materials for inspection doors, leak detection with kerosene during the production process, and the air leakage rate is very low.
Second, vacuum cleaner constructor inlet and outlet air duct arrangement is compact, small airflow resistance.
Third, the maintenance and bag change can be carried out in separate rooms under the condition of non-stop system fan and normal operation of the system. Filter bag mouth with elastic expansion ring, sealing performance is good. The filter bag keel adopts polygonal shape, which reduces the friction between the bag and the keel, prolongs the life of the bag, and is easy to unload the bag.
vacuum cleaner constructor can achieve the purpose of cleaning ash once by using separate chamber air stop pulse jet, so the cleaning cycle is extended, the energy consumption of cleaning ash is reduced, and the pressure air consumption can be greatly reduced. At the same time, the fatigue degree of the filter bag and pulse valve is also reduced, thereby doubling the life of the filter bag and valve disc.
Fifth, vacuum cleaner constructor adopts the upper bag pumping method. After the skeleton is extracted during bag changing, the dirty bag is put into the ash bucket at the lower part of the box and taken out by the manhole, improving the operating conditions of bag changing.
vacuum cleaner constructor After the end of the host equipment, the box and ash bin should be removed from the debris, check the transmission parts and write the lubricating oil (fat), write the oil in the deceleration chassis. vacuum cleaner constructor is a dust removal equipment, once it is found that the exhaust cylinder inlet and outlet of the dust collector is dusty, the dust emission is large, the newly installed clean filter bag is large, the dust passing rate is good when it is first used, and the filter state has not been reached, and the dust emission is large.
With the progress of filtration, dust accumulates on the outer surface of the filter bag to form a dust layer, which makes the pores on the outer surface of the filter bag smaller, the dust removal rate is increased, and the effect of "dust filter" can remove fine dust. Therefore, it is more accurate to determine the dust removal rate of vacuum cleaner constructor after 1 month of continuous use. In addition, vacuum cleaner constructor. Connect the upper limit alarm signal line of the single-needle indicator alarm device with the input of the electronic control instrument. Connect the normally open contact of the travel switch on the three-way valve with the indicator light. Connect the differential pressure transmitter, alarm indicator, electric control instrument power line together. Connect the compressed air, check the compressed air pipeline joints, stop valve, water filter, regulator, oil mist. Start the ash motor and check whether it works normally. vacuum cleaner constructor. At each inlet air short pipe of the ash hopper, the dynamic pressure value is measured together with the leather storage. If the reading is different, the manual butterfly valve is adjusted to make it flat, and the load of each filter chamber is flat. The manual butterfly valve is locked after adjustment. Open the reverse blow manual butterfly valve to the required reverse blow air volume. Electric control cleaning equipment: bag dust collector electric control cleaning operation, start the main fan. When the bag dust collector starts to run the dust, do not immediately start the reverse blowing ash cleaning equipment, and let the dust gradually accumulate in the inner surface of the filter bag.
vacuum cleaner constructor https://www.kaisenfilter.com/KSG-5-5-A-High-Vacuum-Fume-Extractor.html
